These instructions are based on using the PAP2 in its factory default configuration
which is to obtain a dynamic IP address automatically from your router using DHCP,
which is how most people have their home routers configured.For information on
Configuring your PAP2 with a static IP address, please refer to the PAP2 user manual.
We recommend that you read each step through in its entirety before performing
the action indicated in the step.
STEP 1 Connect your router with the supplied Ethernet network cable to the
PAP2. Now connect your phone to the PAP2 Line 1 port. Finally plug
the supplied power cable into the PAP2.
STEP 2 Wait 60 seconds after plugging your PAP2 in.
STEP 3 Pickup the phone connected to the PAP2 and dial the * key on your
phone 4 times.
STEP 4 Have a pen and paper ready. You will hear a message -"Configuration
menu. Please enter option followed by the pound key.",then enter 110
#on your phone. You will now hear a message giving you the Iaddress
of your PAP2 such as - "192.168.1.100 write this number down.
STEP 5 Open a web browser on your computer such as Internet Explorer and
enter the IP address you heard in step 4 as the address
Please note: some browsers will require you to remove lezero's ( 0
's ) in the IP address. For ex ample if you heard "192.168.001.0you
should change this to "192.168.1.10".
STEP 6 Please note, the PAP2 by default does not have a password assigned to it, so you should now see a page that looks like this:
